Expert HVAC Services

Dedicated to Serving Your HVAC Needs

Spartan Heating & Air provides a wide range of HVAC services that are backed by our extensive knowledge and experience in the industry. Our professionals are trained to satisfy simple and complex HVAC needs. From AC maintenance to furnace repair, our company is here to provide you with the kind of HVAC services that’s second to none. With us, you no longer have to look far if you need reliable solutions at rates you can’t resist. We also sell and install LuxAire and Guardian HVAC units.

Repairman Checking An Outside Air Conditioner

Our HVAC Services Include

24-Hour Emergency Service
Maintenance
New Installation
Repair
Spring and Fall Tune-Up

your go-to HVAC service provider.

Contact Our HVAC Professionals Today

Air Conditioning Services

Air Conditioning Maintenance Checklist

1. Condenser Coil – Cleaned as Required

Dirty condenser coils raise refrigerant pressure higher than needed, increasing your electric bill.

2. Check refrigerant Charge

A low or high refrigerant charge can easily go unnoticed and increase the operating costs up to 30%. An improper charge can cause compressor shutdown.

3. Controls and Safeties – Inspected and Tested

Controls and safeties that do not function properly can increase the operational cost and cause other components to fail.

4. Relays and Contactors – Inspected and Cleaned

Worn contacts and loose wire connections can lead to motor or compressor failure.

5. Crankcase Heater – Operationally Inspected

Crankcase heaters that do not work can lead to compressor failure.

6. Unit Wiring – Inspected and Loose Connections Tightened

Loose connections can lead to motor, control, or compressor failure.

7. Temperature and Pressures – Taken and Recorded

An accurate record of your equipment’s vital data indicates potential problems that can be eliminated. A record will be kept with the unit that may reduce emergency service time.

8. Capacitors – Tested

Bad capacitors can lead to compressor and motor failure.

9. Unit Disconnect – Tested

A worn or overheated disconnect blows fuses and is dangerous.

10. Belts and Pulleys – Inspected and Adjusted

Loose belts and worn pulleys decrease the airflow, increase the operating costs, and shorten the compressor’s life. Belts crack and break with age.

11. Condensate Drain – Checked to Ensure It Is Open

Algae and dust can plug a condensate drain, which can cause extensive water damage to your furnace.

12. Thermostat – Checked and Calibrated

Improperly calibrated thermostats cause the unit to run longer than necessary. Every degree your air conditioner operates below 78 degrees can add 5% – 8% to the cost of cooling.

13. Motors- Cleaned, inspected, and balanced

Dirty motors are less efficient and will fail sooner.

Column

Furnace Services

Furnace Maintenance Checklist

1. Heat Exchanger – Inspected for Cracks and Deterioration

Heat exchangers can develop cracks with age. If they exist, there is a risk of serious illness from the toxic fumes emitted.

2. Burners Inspected

Dirty burners can cause poor combustion, soot, and condensation and will shorten the life of the furnace. You pay for useful heat that goes up the chimney instead of going into your house.

3. Fan Switch – Checked and Adjusted

A fan switch that is not properly adjusted can waste energy and cause nuisance fan cycling.

4. Pilot and Pilot Assembly – Cleaned and Adjusted as Necessary

Weak or dirty pilots can easily be extinguished, causing the furnace to shut down.

5. Safety Controls – Operationally Inspected

Safety controls that do not operate can cause dangerous problems.

6. Gas Line – Leak Checked From the Furnace Shut-Off Valve to the Burners

Undetected gas leaks are dangerous.

7. Combustion Air – Openings Will Be Checked

Blocked or restricted combustion air openings can be dangerous.

8. Flue Pipe – Inspected

Flue pipe corrosion or leaks are dangerous.

9. Temperatures and Performance – Recorded

An accurate record of vital data indicates potential problems that can be eliminated.

10. Panels – Secure All Panels

Loose panels can increase the operating costs and cause either a shutdown or a dangerous condition.

11. Controls and Safeties – Inspected and Tested

Controls and safeties that do not function properly can increase the operational cost and cause other components to fail.

12. Air Filter – Replaced at Customer’s Option

A restricted air filter can cause your air conditioning unit to waste energy and shorten the compressor’s life.

13. Voltage and Amp – Draw of the Blower Motor, Compressor, and Condenser Fan Motors Checked and Recorded

Improper voltage and amp draw increase the operating costs and can shorten the life of any motor.

14. Thermostat – Checked and Calibrated

Improperly calibrated thermostats cause the unit to run longer than necessary. Every degree your air conditioner operates below 78 degrees can add 5% – 8% to the cost of cooling.

Check Out Our HVAC Testimonials

Spartan Heating & Air is a trusted name when it comes to HVAC repair and maintenance. But don’t just take our word for it. You may want to read some HVAC testimonials from our valued clients. If you have other questions about our HVAC services, please do not hesitate to give us a call. We’re more than glad to discuss how our services can work for you and your home. We look forward to hearing from you. Contact us today!

Column

Click to edit text. What stands you apart from the competition?

Column

Click to edit text. What stands you apart from the competition?

Column

Click to edit text. What stands you apart from the competition?

Expert HVAC Services

Dedicated to Serving Your HVAC Needs

Our HVAC Services Include

Air Conditioning Services

Air Conditioning Maintenance Checklist

Furnace Services

Furnace Maintenance Checklist

Check Out Our HVAC Testimonials

Spartan Heating & Air

Hours of Operation

Service Area

CONTACT US TODAY